米乐m6网页版登录入口欢迎您！

新闻中心

首页

新闻中心

公司新闻

行业动态

资料下载

联系我们

市场部：
0315-6530512 / 6530519
0315-6530511 / 6530516
15232595913 / 13831518929
15032970915 / 13933354616
15613578090 / 13932588053
邮箱：7048444@163.com
传真：0315-6530555
网址：www.jinshars.com
地址：河北省迁安市经五路东侧(现代装备制造业产业聚集区内)

超低氮燃烧器的正确安装方法

发布时间：

2022-12-22 00:00

来源：

作者：

超低氮燃烧器的良好安装是保证正确和安装使用燃烧器的前提条件，关乎燃烧器是否正常燃烧、正常运作的关键步骤。专业、合理、谨慎的施工操作，是保证安全的途径。

正确的安装步骤如下：
1、将安装法兰石棉垫装于燃烧筒上。

2、将燃烧筒伸入炉膛。

3、对准螺丝孔位置将安装法兰盘固定于炉体上。

4、确认伸入炉膛位置后，将各处的螺丝锁紧，确保燃烧器安装牢固。
5、燃烧器本体安装完毕后，应注意进油管路上应装设过滤器且定期清洗过滤器。

6、连接完成检查管路密封性。

特别说明：

1、安装过程中需要注意燃烧器应水平或垂直安装，不应倾斜安装。

2、燃料储存及管道系统装置及连接施工，验收等，都必须严格符合相关规定和当地安全主管部门的规定，并经合格验收后方可投入使用。

Correct installation method of ultra-low nitrogen burner

The good installation of the ultra-low nitrogen burner is the precondition to ensure the correct installation and use of the burner, and the key step to ensure the normal combustion and operation of the burner. Professional, reasonable and prudent construction operation is the way to ensure safety.

The correct installation steps are as follows:

1. Install the asbestos pad of the mounting flange on the combustion cylinder.

2. Insert the combustion cylinder into the furnace.

3. Align the screw hole position and fix the mounting flange on the furnace body.

4. After confirming the position of extending into the furnace, lock all screws to ensure that the burner is firmly installed.

5. After the burner body is installed, it should be noted that the oil inlet pipe should be equipped with a filter and the filter should be cleaned regularly.

6. Check the pipeline tightness after connection.

Special instructions:

1. During installation, the burner shall be installed horizontally or vertically, and shall not be installed obliquely.

2. The fuel storage and pipeline system devices, connection construction, acceptance, etc. must strictly comply with the relevant regulations and the regulations of the local safety authority, and can be put into use only after passing the acceptance.